Features; Technical Data - Urrea EA1107A Manual De Usuario

The kickback is the result of an inappropri-
ate tool use or an incorrect operation. Can be
avoided following these instructions:
1. Keep a firm grip with both hands on the tool.
Position your body properly to resist the force of
kickback. The operator can control torque reac-
tions if the correct warnings are taken.
2. Never place your hand close to the rotating
accessory. It can cause a kickback over your
hand.
3. Never place your body on the kickback area;
the kickback will propel the tool to the opposite
direction of the rotation abrasive disc.
4. Use extra care when working with edges.
These tend to engage the disc.
5. Don't use the tool with cutting saws. These
produce kickback.

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
3
5
1. ON/OFF TRIGGER SWITCH
2. LOCK-OFF/LOCK-ON BUTTON
3. SPINDLE-LOCK BUTTON
4. GRINDING DISC
5. INNER FLANGE
6. DISC GUARD
7. SIDE HANDLE

TECHNICAL DATA

EA1107A
VOLTAGE-FREQUENCY
NO LOAD SPEED
DISC CAPACITY
SPINDLE THREAD
POWER
WEIGHT
7
6
4
120 V ~ 60 Hz
8 500 r/min
7"
5/8" (16 mm)
2 600 W
6, 35 kg (14 lb)
EA1109A
VOLTAGE-FREQUENCY
NO LOAD SPEED
DISC CAPACITY
SPINDLE THREAD
POWER
WEIGHT
ASSEMBLY INSTRUCTIONS
WARNING: Remove the grinder from the
carton and examine it carefully. Do not discard
the carton or any packaging material until all
parts are examined.
LATERAL HANDLE
The lateral handle must
be used always that
the machine is run-
ning. Screw the lateral
handle inside the holes,
could be on
the right, left or superior side. Your choice is
determined by your convenience and ability to
keep the complete control.
GUARD
1
The guard is a security device to prevent
injuries caused by pieces of abrasive disc.
1. Disconnect the plug
from the electrical out-
let.
2
2. Loosen the clamp.
3. Position the guard at
the required angle.
4. Tighten the clamp
again.
INSTALL AND REMOVE THE ABRASIVE DISC
To Install:
1. Disconnect the plug from the electrical outlet.
Make sure that the guard is securely in place.
2. Remove the outer flange.
3. Check that the in-
ner flange is properly
seated on the spindle.
It will click into place
on the spindle, and will
cause the spindle to
rotate when the inner
flange is rotated.
4. Check the rated speed on the grinding disc.
Do not use a disc with a rated speed lower than
the speed shown on the grinder's nameplate.
NOTE: The maximum disc thickness is 1/4"
(6,5mm), and the spindle opening is 7/8"
(22,3mm).
E N G L I S H •
U s er 's M an u al
120 V ~ 60 Hz
6 500 r/min
9"
5/8" (16 mm)
2 600 W
6, 45 kg (14,22 lb)
11