Basic Radio Operations - Motorola T80 Manual Del Usuario

68015000918_a.book Page 4 Thursday, September 13, 2012 2:17 PM
Using the Battery Support Bracket :
1. Remove the rechargeable NiMH battery pack from the radio.
2. Place the battery support bracket into the charging cradle.
3. Install the NiMH battery pack into the charging cradle.
Ensure that the charging contacts are correctly aligned.
4. LED indicator will illuminate and remain illuminated as long
as the radio is in the charger.
Note: Charge the battery pack for 14 hours.

Basic Radio Operations

Read this reference guide completely before attempting to
operate the unit.
Turning your Radio On/Off
To turn your radio ON, turn the rotary knob clockwise.
To turn your radio OFF, turn the rotary knob counterclockwise.
Adjusting the Volume
Increase volume by turning the rotary knob clockwise.
To decrease volume, turn the rotary knob counterclockwise.
Adjusting the Sound (Key Beeps)
Your radio emits a beep each time one of the buttons is pressed
(except the PTT and
Press and hold the
switch the sound ON/OFF.
Navigating through the Menu
Your radios has two Menu functions: Select Menu and Common
Menu.
1. To enter the Select Menu, press the SEL/
2. To enter the Common Menu, press the MENU/GRP button.
3. Additional presses of the SEL/
button will advance you through the Menu.
4
button).
button while turning the radio ON to
button.
button or MENU/GRP
4. To exit the Menu function, do one of the following :
a. Press the MENU/GRP button,
b. Press the PTT button
c. Wait 10 seconds until the unit automatically returns to
"Normal" mode.
Talking on Your Radio
1. Hold your radio 5–8 cm from your mouth.
2. Press and hold the PTT button while speaking. The
appears on the display.
3. Release the PTT button. You can now receive incoming
calls. When you do, the
respond, repeat procedure from step 1.
Note: When you continue to transmit for 60 seconds, the
radio emits TX Time Out tone and the
The radio will stop transmitting.
In order to speak to someone, both your radios must
be set to the same channel and Sub-Code. Refer to
"Selecting a Channel and a Sub-Code" below.
Selecting a Channel and a Sub-Code
To select a Channel:
1. SEL/ button to enter Select Menu. Advance until the
Channel indicator blinks.
2. or to the required channel.
To select a Sub-code :
1. SEL/ button to enter Select Menu. Advance until the
Sub-code indicator blinks.
2. or to the required Sub-code.
3. Exit the Select Menu.
appears on the display. To
icon flashes.