Cloning Radio Using Two Sucs And A Radio-To- Radio Cloning Cable (Optional Accessory) - Motorola DTR720 Manual De Instrucciones

English
1 Turn on the Target radio and place it into one of the
MUC Target Pockets.
2 Power the Source radio by performing the following
actions:
a Press the Menu/
OK→Advanced→Cloning→Radio Cloning
b Put the radio inside the MUC pocket.
c Press the Menu/OK button.
The display shows Cloning....
If successful:
• The display shows Cloned Successfully.
If unsuccessful:
• The display shows Cloning Failed.
NOTE:
After completing the cloning process, user
can replace the Slave Radio with another
Slave Radio and by pressing the Menu/OK
button on the Master radio to clone on
second Slave Radio.
48
3 Exit the 'cloning' mode by long pressing the Home/
Back button.
4 If cloning fails, refer to
Mode on page 50.
When ordering the MUC, refer to P/N# PMPN4464_.
NOTE:
User should not remove the radios from the
MUC when cloning is on-going.
7.5.2
Cloning Radio Using Two SUCs and
a Radio-to- Radio Cloning Cable
(Optional Accessory)
Before starting the cloning process, ensure that you have
the following hardware:
• A Cloning Cable (P/N# HKKN4028_).
• A fully charged battery in each of the radios.
• Two Single-Unit Chargers (SUC) for radio cloning.
• Ensure that the radios are turned on.
Troubleshooting Cloning