Operation; Setting The Cutting Angle; Setting The Stroke Rate; Adjusting The Pendulum Stroke - Parkside PSTDA 18-Li B2 Traducción Del Manual De Instrucciones Original

Operation

Setting the cutting angle

♦ Undo the locking screws
Allen key and pull the baseplate
♦ Adjust the cutting angle to 0°/15°/30°/45°
with the aid of the markings on the baseplate .
Push the baseplate
ing pin engages in the toothing
♦ Re-tighten the locking screws
GB
key.
MT

Setting the stroke rate

The ON/OFF-switch
Pressing the ON/OFF switch
a low speed. Increasing pressure increases the speed.
NOTE
► The integrated motor brake ensures rapid
stoppage.

Adjusting the pendulum stroke

♦ You can use the pendulum stroke switch
to adjust the pendulum movement of the saw
blade . You can achieve fine, clean-cut edges
without pendulum movement (setting "0").
Deactivate pendulum movement when working
on thin workpieces. You can achieve an increas-
ingly fast work rate if the pendulum stroke is
activated (settings 1–3).
Switching the appliance on/off
Switching the appliance on:
♦ Push the safety lock-out
and keep it pressed.
♦ Press the ON/OFF switch
Once the saw is running, you can release
the safety lock-out
illuminates when the ON/OFF switch
depressed lightly or completely. This allows
illumination of the work area in low lighting.
Switching the appliance off:
Release the ON/OFF switch
44
with the supplied
to the rear.
to the front so that the lock-
.
with the Allen
has a variable speed control.
lightly yields
to the left or right
.
. The working light
is
.

Maintenance and cleaning

WARNING! RISK OF INJURY! Switch
the power tool off and remove the
battery before starting any work on the
power tool.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Use a soft, dry cloth to clean the housing.
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. Optimum storage
conditions are cool and dry.
■ Clean the appliance after completing your
sawing work.
■ Remove any dirt (e.g. sawdust). Clean the saw
blade mounting, if necessary with a brush or
by blowing it out with compressed air.

Warranty

You are provided a 3-year warranty on this
appliance, valid from the date of purchase.
This appliance has been manufactured with
care and inspected meticulously prior to
delivery. Please retain your receipt as proof
of purchase. In the event of a warranty claim,
please contact your Customer Service unit by
telephone. This is the only way to guarantee
free return of your merchandise.
The warranty only covers claims for material and
manufacturing defects, not for damage sustained
during carriage, components subject to wear
and tear or damage to fragile components such
as switches or batteries. This appliance is intended
solely for private use and not for commercial
deployment.
The warranty shall be deemed void in the case
of misuse or improper handling, use of force or
interventions which were not carried out by one
of our authorised Service centres. Your statutory
rights are not restricted by this warranty.
The warranty period is not extended in conse-
quence of repairs carried out under the warranty.
This also applies to replaced and repaired compo-
PSTDA 18-Li B2