Make Sure The Camera Is Loaded Properly; Seal The Case - Olympus PT-034 Manual De Instrucciones

Make sure the camera is loaded properly.

Check the following points before sealing the Case.
Is the digital camera loaded properly?
Is the camera's image blur correction function set properly?
Is silica gel inserted deep in the specified location?
Is the O-ring attached properly to the opening on the Case?
Is there any dirt or foreign matter on the O-ring or the O-ring contact
surface on the front lid?
Has maintenance of the waterproof function been performed?

Seal the Case.

Gently close the rear lid of the Case (so that the O-ring does not slip
out of the O-ring groove), hook the buckle on the edge of the rear lid
and tilt the buckle open/close lever in the direction of the arrow to seal
the Case.
CAUTION : • Seal the Case by turning both buckle lock levers down
in arrow direction. When one of the buckles is left
open, the Case will not be sealed and water leakage
will be caused.
• Close the rear lid of the Case so that the LCD hood
and the lens cap strap don't catch. If they catch, water
leaks may result.
E-18