Mitsubishi Electric Mr.Slim SLZ-KA25 Manual De Instrucciones página 4

2. Operation
A
ON/OFF
TOO TOO
WARM COOL
1
B
FAN SELECT
AUTO COOL
VANE TIME
HEAT DRY
MODE
2
2
RESET
For wireless remote controller
A
ON/OFF
TOO TOO
A WARM COOL
1
FAN SELECT
AUTO COOL
VANE TIME
HEAT DRY
1
MODE
RESET
For wireless remote controller
4
˚C
˚C
A
SIMPLE
TEMP.
ON/OFF
1
MENU ON/OFF FILTER
BACK MONITOR/SET DAY CHECK TEST
PAR-21MAA CLOCK OPERATION CLEAR
For wired remote controller
˚C
˚C
SIMPLE
TEMP. ON/OFF
MENU ON/OFF
FILTER
BACK MONITOR/SET DAY
CHECK TEST
PAR-21MAA CLOCK OPERATION CLEAR
For wired remote controller
2.5. Mode select
1If the unit is off, press the ON/OFF button to turn it on.
For wireless remote controller
MODE
2Press the operation mode button and select the operation mode.
Each time the operation mode
MODE
Automatic (cooling/heating) mode
s
Cooling mode
Drying mode
Heating mode
For wired remote controller
2Press the operation mode (
mode.
B
Cooling mode
s
Drying mode
Fan mode
Heating mode
Automatic (cooling/heating) mode
Information for multi system air conditioner (Outdoor
unit: MXZ series)
s s s s s Multi system air conditioner (Outdoor unit: MXZ series) can con-
nect two or more indoor units with one outdoor unit. According to
the capacity, two or more units can operate simultaneously.
• When you try to operate two or more indoor units with one outdoor unit
simultaneously, one for the cooling and the other for heating, the opera-
tion mode of the indoor unit that operates earlier is selected. The other
indoor units that will start the operation later cannot operate, indicating
an operation state.
In this case, please set all the indoor units to the same operation mode.
• There might be a case that the indoor unit, which is operating in
(AUTO) mode. Cannot change over to the operating mode (COOL ↔
HEAT) and becomes a state of standby.
• When indoor unit starts the operation while the defrosting of outdoor
unit is being done, it takes a few minutes (max. about 15 minutes) to
blow out the warm air.
• In the heating operation, though indoor unit that does not operate may
get warm or the sound of refrigerant flowing may be heard, they are not
malfunction. The reason is that the refrigerant continuously flows into it.
2.6. Selecting a temperature
s s s s s To decrease the room temperature:
1Press button to set the desired temperature.
A The selected temperature is displayed.
• Each time you press the button, the temperature value decreases by 1 °C.
s s s s s To increase the room temperature:
1Press button to set the desired temperature.
A The selected temperature is displayed.
• Each time you press the button, the temperature value increases by 1 °C.
• Available temperature ranges are as follows:
Cooling/Drying: 19 - 30 °C
Heating: 17 - 28 °C
Automatic: 19 - 28 °C
• The display flashes either 8 °C - 39 °C to inform you if the room tem-
perature is lower or higher than the displayed temperature.
button is pressed the moves. (A)
) button and select the operation