STOK Island SGP2220SB Manual Del Operador página 12

STEP 7: ASSEMBLING THE FRAME TO THE
FIREBOX
See Figure 11.
Remove the following hardware from the blister pack:
AA - 2 Screws (M5 x 12 mm)
DD - 2 Screws (M5 x 40 mm)
BB - 4 Flat washers (M5)
CC - 4 Lock washers (M5) EE - 2 Nuts (M5)
 Position the frame over the table top and firebox as shown.
NOTE: The right side legs (with large wheels) should be
on the same side as the firebox.
 Insert the 4 frame leg sections into the tubes as shown,
aligning holes in the legs with holes in the tubes.
 To attach the right side of the frame, slide a lock washer
(CC) and flat washer (BB) over each screw (AA). Insert
the screw through the holes in the legs and tubes.
 To attach the left side of the frame, insert a screw (DD)
through the holes in the legs and tubes. Add a flat washer
(BB), lock washer (CC), and nut (EE) to the end of the
screw and tighten.
 Make sure all hardware is securely tightened.
LEFT SIDE
FLAT
NUT
WASHER
(EE)
(BB)
LOCK
WASHER
(CC)
SCREW
(DD)
Fig. 11
ASSEMBLY
HOOK
HOSE
INSERT
LEGS INTO
TUBES
SCREW
(AA)
RIGHT SIDE
STEP 8: SECURING GAS HOSE
See Figure 12.
There is a hook on the underside of the storage shelf for
keeping the hose in place. The hose should be attached to
the hook before turning the grill upright.
Remove the following hardware from the blister pack:
JJ - 1 Bolt (M4 x 20 mm)
FF - 1 Acorn nut (M5)
 Fasten gas hose into hose bracket, located under prep
table.
 Slide bolt (JJ) through hole in bracket and secure with
acorn nut (FF).
NOTE: Should not be so tight around hose as to pinch
hose.
BOLT
(JJ)
Fig. 12
12
ACORN
HOSE
NUT
BRACKET
(FF)
GAS
HOSE