Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then tighten
both screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with
screwheads in bottom of canopy. Turn canopy cover
to the right (clockwise) until it stops.
8. Blade Assembly.
WARNING: To reduce the risk of serious bodily
injury,
DO NOT use power tools to assemble the
blades. If overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
one of the hardware packs. Hold blade arm up to
blade and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first and
then tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (save blade arm screws and lock washers
to secure blade arms). Align blade arm holes with
motor screw holes and attach blade arm with lock
washers and blade arm screws. Before securing
screws permanently, repeat with remaining blade
arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
screw
plastic
motor
lock
lock washers
blade arm
screws
page 7
hanging bracket
canopy
screw
canopy cover
blade screw and washer
motor housing
blade attachment
screws and washers
blade
blade arm
Capítulos
Tabla de contenido
