Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. Fan Assembly. (cont. )
With the hanging bracket secured to the outlet box and able
to support the fan, you are now ready to hang your fan. Grab
the fan firmly with two hands. Slide downrod through
opening in hanging bracket and let hanging ball rest on the
hanging bracket. Turn the hanging ball slot until it lines up
with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the stepladder in
place and to lift the fan up to you once you are set on the
ladder.
NOTE: The important safety precautions and instructions appearing
in the manual are not meant to cover all possible conditions and
situations that may occur. It must be understood that common sense
and caution are necessary factors in the installation and operation
of this fan.
6. Wiring.
WARNING: Turn off circuit breakers to current fixture
from breaker panel and be sure operating light switch
is turned to the OFF position.
CAUTION: Be sure outlet box is properly grounded and
that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to below, please use a qualified electrician.
Note: Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK wire from fan to BLACK wire from
ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together from fan
to BARE/GREEN wire from ceiling with wire connector
provided.
Since this fan does not come with a light kit, you will
need to cap off the BLUE wire with a wire connector.
[Note: If you elect to purchase a light kit for the fan,
the BLUE wire from the fan must be connected to the
BLACK wire from the ceiling instead.]
white supply wire
black supply wire
from ceiling
black
white
white
black
from fan
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
This fan is remote control adaptable (remote control
sold separately).
page 6
hanging bracket tab
hanging ball slot
ground
(green or bare)
ground
(green
or bare)
*
Capítulos
Tabla de contenido
