Preparation; During Operation - Stiga Park series Manual De Uso

(Translation of the Original Instructions)
In the event of changes in ownership or
loan of the machine, make sure the fu-
ture user reads the instructions for use
provided in this manual .
Never carry children or other passen-
gers on the machine: they might fall off
and be seriously injured or inhibit safe
use of the machine .
The operator of a machine must care-
fully follow the driving instructions, par-
ticularly:
a . the need for care and concentration when
using machines;
b . that control of a machine sliding on a slope
will not be regained by the application of the
brake. The main cause behind a loss of ma-
chine control are:
• insufficient wheel grip;
• being driven too fast;
• inadequate braking;
• the type of machine is unsuitable for its
task;
• lack of awareness of the effect of ground
conditions, especially slopes;
• Incorrect use of the machine as a towing
vehicle;
The machine is equipped with a series
of safety microswitches and devices
which must never be removed, altered
or tampered with. Removing these de-
vices invalidates the warranty and the
manufacturer declines any responsi-
bility. Always check the safety devices
work before using the machine.
3 .2

PREPARATION

• When using the machine always wear sturdy,
slip-resistant footwear and long trousers.
• Never activate the machine when barefoot or
wearing open-toe sandals.
• Do not wear chains, bracelets, cumbersome
clothing with strings or ties.
• Tie back long hair. Always wear hearing pro-
tectors.
• Thoroughly inspect the area where the
equipment is to be used and remove all objects
which may be thrown by the machine (stones,
sticks, metal wire, bones, etc.)
ENGLISH
CAUTION: DANGER! The fuel is highly
flammable.
a . store fuel in containers specifically
b . refuel using a funnel and outdoors
c . Add fuel before starting the engine.
d . If fuel is spilled, do not attempt to
e . Always replace caps of fuel tanks and
Replace faulty silencers .
Before using, always carry out a visual
inspection, particularly of the cutting
device, seeing that the screws and cut-
ting devices are not worn or damaged.
Replace a worn or damaged cutter bla-
de and screws as a set to preserve ba-
lance .
Any repair shall be performed by an au-
thorized service centre .
Check the condition of the battery at
frequent intervals . Replace if damages
to the casing, cover or terminals are
found .
3 .3

DURING OPERATION

Never start the engine in a confined
area where hazardous carbon monoxi-
de gases can build up .
All starting operations have to be ef-
fected in an open or well ventilated
area!
Always remember that exhaust gases
are toxic!
Mow only in daylight or with good artifi-
cial light in good visibility conditions .
Keep persons, children and animals
away from the working area.
designed for this purpose;
only. Do not smoke while refuelling or
whenever handling the fuel;
Never remove the cap of the fuel tank
or add fuel while the engine is run-
ning or when the engine is hot;
start the engine but move the ma-
chine away from the area of spillage
and avoid creating any source of igni-
tion until the fuel has evaporated and
the fumes dispersed;
container securely.
EN
7