Adjusting The Airflow; Maintenance And Cleaning - Parkside PDFP 500 B2 Traducción Del Manual De Instrucciones Original

Adjusting the airflow
NOTE
► We recommend starting with the airflow set
to maximum. To do this, open the airflow
regulator
in the section "Increasing the airflow".
Increasing the airflow:
NOTE
► Increasing the airflow is generally advisable
GB
if the dispersion is too coarse.
MT
♦ Turn the airflow control
Decreasing the airflow:
NOTE
► Decreasing the airflow is generally advisable
if the paint mist is too strong.
♦ Turn the airflow control

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
NOTE
► Thorough cleaning after every use is very
important for safety and operation. Other-
wise, the needle could get blocked and
proper operation of the appliance cannot
be guaranteed.
■ Wear suitable gloves when cleaning.
■ Do not use any hydrocarbon-based solvents
like benzene, ethyl chloride, etc., as these could
trigger chemical reactions with some of the
materials in the paint spray gun. This can lead
to dangerous reactions.
36
to maximum as described below
anticlockwise.
clockwise.
CAUTION!
► Never immerse the paint spray gun com-
pletely in solvent.
■ After every use, squirt thinners (only outside
– risk of explosion!) or water through the
appliance.
♦ To clean the housing, the nozzle head
spray holes inside it, use the supplied cleaning
brush or a cloth. Never use petrol, solvents or
cleansers which can damage plastic.
♦ First, unscrew the stroke limiter screw
it in an anticlockwise
♦ Remove the spring
♦ Remove the needle
♦ Clean the needle
(see fig. B).
♦ Replace the needle
♦ Push the spring onto the end of the needle
♦ Screw the stroke limiter screw
it clockwise .
♦ Screw the flow cup
spray gun.
♦ Remove the filter
clean it with the cleaning brush.
♦ Also clean the inner screw thread
cup using the cleaning brush (see fig. D).
♦ Replay the filter in the spray gun (see fig. C)
and screw the flow cup
onto it.
♦ For rust protection purposes, you can spray a
little sewing machine oil through the spray gun
after cleaning.
♦ Oil all moving parts from time to time.
♦ After cleaning the needle, the thread and seal
must be lightly greased with a suitable lubricant.
♦ Do not use any silicon-based lubricants.
♦ Store compressed-air appliances only in dry
rooms.
and the
by turning
direction.
.
using pliers (see fig. A).
carefully with the brush
in the paint spray gun.
tight by turning
anticlockwise off the
as shown in fig. C and
of the flow
clockwise firmly
PDFP 500 B2
.