Additional Safety Advice For Paint Spray Guns; Advice On Use; Din-Sec / Viscosity; Preparing The Sprayed Medium - Parkside PFS 100 B2 Traducción Del Manual De Instrucciones Original

General safety advice for electrical power tools / Advice on use
and advice. Electrical power tools are dan-
gerous when they are used by inexperienced
people.
e) Look after the device carefully. Check
that moving parts are working prop-
erly and move freely. Check for any
parts that are broken or damaged
enough to detrimentally affect the
functioning of the device. Have dam-
aged parts repaired before you use
the device. Many accidents have their origins
in poorly maintained electrical power tools.
f) Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and advice, and
the stipulations drawn up for this par-
ticular type of device. In doing this, take
into account the working conditions
and the task in hand. The use of electrical
power tools for purposes other than those in-
tended can lead to dangerous situations.
Additional safety advice
for paint spray guns
½
The spray gun must never be used for
spraying inflammable substances.
Spray guns must never be cleaned
using inflammable solvents.
½
If you do not know the level of danger
a substance presents, do not spray it.
½
Precise observation of the hazard
warnings, information and data
sheets available from the sprayed
medium manufacturer is essential.
½
Wear a breathing / dust mask!
The inhalation of paint mist and sol-
vent vapour is hazardous to health.
½
Work in adequately ventilated
spaces only.
½
Wear protective glasses!
½
Never aim the spray at living
creatures.
All manuals and user guides at all-guides.com
½
½
½
©
©
The Parkside paint spray gun PFS 100 B2 can be
used to apply sprayed media with a viscosity up to
80 DIN-sec. Viscosity is determined in a simplified
measuring procedure using the supplied measuring
cup (see Fig. C).
1. Immerse and fill the supplied measuring cup
2. Lift the measuring cup
3. Measure the time in seconds it takes for the
4. If the value is too high, incrementally add and
5. Remeasure the DIN-seconds value.
©
NOTE: Most paints, varnishes etc. in the shops
are intended to be applied by brush not spray. To
achieve the best spraying result, you should prepare
your paint or varnish etc. in accordance with DIN
guidelines to achieve a suitable viscosity (see table).
DANGER OF EXPLOSION! Do
not use the device in environments
containing gases, open flames, fires
or gas-operated water heaters.
NO SMOKING!
Paint and solvents (thinners) must
have a flashpoint above 21°C.

Advice on use

DIN-sec / Viscosity

to the top with the medium to be sprayed.
12
to be sprayed and let the liquid flow out (see
Figure C).
flow of liquid out of the measuring cup to cease.
This time is the "DIN-seconds (DIN-s)" value of
viscosity.
mix in small quantities of a thinner compatible
with the medium to be sprayed. Proceed in ac-
cordance with the section about "Preparing the
sprayed medium".
Repeat this procedure until a value is obtained
that complies with the values in the table.

Preparing the sprayed medium

12
out of the medium
GB/MT 39