Preparing The Surface; Switching The Appliance On/Off; Setting The Paint Jet Pattern; Adjusting The Paint Flow - Parkside PDFP 500 B2 Traducción Del Manual De Instrucciones Original

Ocultar thumbs Ver también para PDFP 500 B2:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Connect the compressed air hose with the
quick-action coupling to the compressed-air
connection
on the appliance. The connection
locks automatically.
Set the working pressure on the filter pressure
reducer of the compressed air source to 3 bar.

Preparing the surface

Carefully cover a large area around the spray
surface. Any surface that is not masked could
become contaminated.
Ensure that the spray surface is clean, dry and
free of grease.
Polished surfaces should be lightly sanded and
the sanding dust removed.
Switching the appliance on/off
Working methods:
Fit the filter in the gun (see fig. C).
Open the vent
while working.
When thinning, ensure that the spray material
and the thinners are suitable for each other.
Using an unsuitable thinner can lead to the
formation of lumps which, in turn, can block the
spray gun.
Screw the flow cup
gun.
Fill the flow cup
with spray material and
screw the lid
on firmly.
Hold the spray gun at a constant distance from
the object. The ideal spraying distance is ap-
prox. 15 cm.
Work out the right settings by carrying out a test.
Do not switch the appliance on/off over the
spray surface, rather start/end the spraying
process approx. 10 cm from the spray surface.
Switching on:
To switch on, pull the trigger
pressed in.
Switching off:
To stop working, simply release the trigger
PDFP 500 B2
clockwise onto the spray
and keep it
.

Setting the paint jet pattern

The appliance has two settings: round jet and
broad jet.
Round jet
Setting the round jet:
Use the round jet for small surfaces, corners
and edges.
Turn the control
clockwise
Setting the broad jet:
You can use the broad jet vertically or horizon-
tally for larger surfaces.
Turn the control
clockwise
The nozzle head
position between the horizontal and the vertical.
Adjusting the paint flow
NOTE
The front locking bolt is designed to limit the
adjustment range of the stroke limiter screw
Increasing the paint flow:
Turn the stroke limiter screw
Decreasing the paint flow:
Turn the stroke limiter screw
Broad jet
.
.
can be turned into any
anticlockwise.
clockwise.
GB
MT
.
35
Tabla de contenido
loading

Tabla de contenido