Section 1 - General Information; Unpacking; Accessory Box; Assembly - Generac XP Professional Serie Manual Del Propieratio

1.1 UNPACKING

• Remove all packaging material.
• Remove separate accessory box.
• Remove carton off the generator.

1.1.1 ACCESSORY BOX

Check all contents (Figure 1). If any parts are missing or damaged
locate an authorized dealer at 1-888-775-6937.
Contents include:
• Wheel Axle
• 2 – Washers
• 2 – Cotter Pins
• Spark Plug
• Air Filter
• Oil Filter
• 2 – 1 Quart SAE 30 Oil Bottles
Figure 1 – Accessory Boxes

1.2 ASSEMBLY

Read entire Owner's Manual before attempting to assemble or
operate the generator. The generator requires some assembly
prior to using it. If problems arise when assembling the generator,
please call the Generator Helpline at 1-888-775-6937.

1.2.1 ASSEMBLING THE WHEEL KIT

The wheel kit is designed to greatly improve the portability of the
generator. A pair of pliers is needed for assembling the wheel kit.
The wheel kit is not intended for over-the-road use.
• Refer to Figure 2 and install the wheel kit as follows:
• Generator will be resting on an accessory box after box is cut
back.
• Open end of accessory box to remove contents.
• Slide the axle through the holes on the axle brackets.
4
Section 1 – General Information
Portable Generator System
• Oil Funnel
• 2 – Wheels
• Extension Cord
• 12 Volt Adaptor Plug Charger
• Spark Plug Wrench
• Shop Towel
NOTE:
• Slide one wheel onto the axle with flat washer to the outside.
• Insert retaining pin and using pliers, bend out the ends to
prevent the pins from falling out of the axle. Repeat for other
side.
• Lift the engine side of the generator to pull out the insert.
Figure 2 – Wheel Assembly
Axle

1.2.2 BATTERY CONNECTION

The battery shipped with the generator has been fully charged.
A battery may lose some of its charge when not in use for
prolonged periods of time. If the battery is unable to crank the
engine, plug in the 12V charger included in the accessory box
(see the Charging a Battery section). RUNNING THE GENERATOR
DOES NOT CHARGE THE BATTERY.
This wire was deliberately left detached for shipping. To operate
unit, attach this wire to terminal on starter motor as shown. Do not
overtighten. See Figure 3.
Figure 3 - Battery Connections
Flat Washer
Cotter Pin
Wheel
NOTE:
Starter Wire
(RED to Contactor)