Troubleshooting - Kokido K900CBX Manual Del Propietário

TROUBLE SHOOTING
Symptom Possible reason
Running time is too long
Nozzle was set on large degree
Cable twists or
Cable was not fully released
coils up
Obstruction in pool
Excess cable in the pool
Gets stuck on main drain cover
Nozzle was set in improper
degree
Customized pool shape
Cleaner does not
reach all pool
Power Supply & Control unit was
areas
not positioned properly
Pool filtration system is on
Cable not long enough in pool
Power
well-connected
Cleaner does not
Damaged during transportation
work
Local
suitable for cleaner
Cleaner does not
sink to the pool Air trapped inside cleaner
bottom
Cleaner inside or mesh filter
plate is clogged with excessive
Cleaner does not debris
catch the debris
Rectangular suction nozzle at
the bottom of the filter tray is
clogged.
Suction nozzle door is clogged
and opened
Debris escapes
Suction nozzle door detached
from the cleaner
cord is not
rated voltage is not
Corrective actions
Stop the cleaner and uncoil the cable manually.
Adjust nozzle to the smaller degree. Refer to section
"How the cleaner works" & "Propelling nozzle setting"
Unplug power line, release cable
Remove obstruction in pool
Remove excess cable from the pool and determine the
required length of cable.
Turn off pool filter system
Refer to section "How the cleaner works" &
"Propelling nozzle setting".
Adjust the nozzle to large degree for a larger moving
radian path. Refer to section "How the cleaner works"
& "Propelling nozzle setting"
Relocate the Power Supply & Control unit to a spot
where the cleaner can have enough cable length to
move in the entire pool.
Turn off pool filter system to stop the water circulating
as that might affect the cleaner's coverage.
Release more cable into the pool.
Re-plug the power cord and cable line according to the
instructions provided.
Contact local dealer.
Contact local dealer
Turn off the power; submerge the cleaner in the pool
again according to the instructions listed in this
manual. Contact dealer if it is a frequent occurrence.
Clean the cleaner inside and the mesh filter plate .
Clean the suction nozzle.
Clean the suction nozzle
Follow below steps to attach the door to the opening:
1) Place the spring onto the door side post as shown in
below diagram. Pay attention to the spring end
direction.
2) Put the short hook of the spring to the rib and
attach the door post into the notch of the rib as
shown.
3) Attach the other door post to the notch of the other
rib.
17