Working Mode Selection; Control Panel - Kokido K900CBX Manual Del Propietário

For pools with a flat bottom, release the cleaner from the middle of the longer side of
the pool.
Note:
1. In order to avoid scratching/damaging the pool (particularly vinyl and soft
wall pools), avoid contact with the pool walls while placing the cleaner inside
the water.
2. Make sure the mesh filter plate is in place before placing the cleaner into the
water.
3. Make sure the fiter tray is secured by the side knobs. Side knobs should
completely clip into the cleaner by being pressed inward, as shown below.
CAUTION:
- Ensure all the air inside has been evacuated completely (when you no longer see air
bubbles discharged from the cleaner) and the cleaner sinks to the bottom of the pool.
- Spread out the floating cable over the pool water surface as evenly as possible, and
make sure there are no kinks or coils in the cable.
- Do not place the cable plug in water.
- Do not move the floats along the cable

Working mode selection

Control Panel

CAUTION! Do not lift the protective film on the control panel.
*Tap (hold for 1 second) the button to trigger the feature.
Selection
Item Feature
mode
1 ON/OFF
2 CYCLE
M
Indicator
3
light bar
Function
Power On/Off
About 1 hour operation.
S
About 1.5 hours
operation.
About 2 hours operation.
L
Corresponding light bar
begin to flash after the
mode is selected.
13