Operation; Submerging The Cleaner Into The Pool - Kokido K900CBX Manual Del Propietário

OPERATION

WARNING!
- To prevent the cleaner's cable from getting pulled and twisted, it is recommended to
turn off your pool's filtration system while your cleaner is in operation.
- NEVER operate the cleaner when people are in the pool.
- Check the power cord and cable for cuts before starting the operation. NEVER operate
the cleaner or Power Supply & Control unit if the power cord or floating cable is worn
or damaged. Store the cord or cable to prevent it from being damaged by the lawn
movers, hedge trimmers and other equipment.
- In order to avoid overheating and potential damage of components, never cover the
power supply and control unit.
- NEVER permit children to operate this cleaner.
- Do not use the cleaner if the pool temperature does not fall into this range:
10°C – 40°C (50°F – 104°F)
- If there are stones, roots or metal corrosion in contact with the underside of the liner,
clean them out before operating the cleaner. If necessary, have a qualified professional
do the cleaning.
- If the liner is brittle or damaged, have a qualified professional perform the necessary
repairs or liner replacement before operating the cleaner.
- Remove articles from the pool deck/top frame before operating the cleaner.
- Remove the pool ladder from the pool before operating the cleaner.
CAUTION:
- In order to avoid causing severe damage to the cleaner, do not switch on the cleaner
until it is fully submerged in water.
- Remove hazardous obstacles such as children's toys, floating loungers and chemical
dispensers, etc. from the pool before placing the cleaner in water and initiating
operation.
- The cleaner must be installed and operated as specified in this manual.
- Do not restart the cleaner immediately after it stops. Wait for at least 30 seconds
before restarting.
- Do not drive the cleaner out of water. Otherwise, it will damage the cleaner
- Must clean out the debris from the cleaner and mesh filter plate before each
operation. Refer to "CARE & MAINTENANCE" section for how to remove the debris.
Excessive debris inside the cleaner will change the cleaner's weight and speed, which
can cause it to deviate from the selected path.

Submerging the cleaner into the pool

- Use the cleaner's handle to lift it, hold the cable with your free hand, and gently place
the cleaner into the water. Make sure the front of the cleaner (other side of the cable)
is facing the water upon entry. Continue to hold the cable until the cleaner is filled
with water (no more bubbles escaping) and begins to sink to the pool bottom. Release
the rest of the cable. The cleaner is ready to operate.
12