Replacing The Steering Drive Belt - NAMCO MOTOCROSS GO! Deluxe Manual Del Operador

8-8 Replacing the Steering Drive Belt

1. Remove the Steering assembly.
2. Remove the Steering Potentiometer.
3. Slacken the 4off Hex head screws (M6x16).
4. Slacken the Lock Nut (M6) and Adjustment Screw (M6x50), to remove the
tension from the Drive Belt, and remove the Drive Belt.
5. Reassemble in reverse order.
6. After re-assembly and refitting in to the bike, ensure that the game is
re-initialized before normal game play.
Note:
When refitting the Drive Belt adjust the Adjuster screw (M6x50) to obtain a
belt tension of 7.5~9.5kgf. When tensioned correctly a 0.5kgf, applied to the
belt as shown, will allow 1.0~1.5mm movement of the belt and a 1kgf
applied will allow 2.0~2.5mm of movement. Tighten the Lock Nut (M6) to
prevent the adjuster screw from moving.
(see section 8-7 (1-4) page 64)
(see section 8-6 (2-3) page 63)
(see section 7 page 54)
Page 65