Initialization; Self Test - NAMCO MOTOCROSS GO! Deluxe Manual Del Operador

7. INITIALIZATION

Adjustments when Replacing Parts (Initialization)
The following adjustments should always be performed after replacing the
Game PC Board, ROM, or Control Potentiometers.
The game will not operate correctly if these adjustments are not made.
1. Ensure that the Bike and Handlebar assemblies are in their central stand-
by positions.
2. Slide the Test switch "ON" and select 'BIKE INITIALIZATION' from the
menu screen
3. After the five seconds the initialization is complete and the following
screen will be displayed.
4. When the value of 'GAS', 'BRAKE', 'STEER', and 'BANK' is around '0000',
and 'OK' is displayed when each item is operated, the adjustment is
completed. Otherwise, select 'RETRY' to readjust the unit.
5. Slide the test switch off to return to normal game mode.

7-1 Self Test

This game automatically performs a self test at power-up for several seconds,
during which time the monitor display remains blank.
If an error is detected, the corresponding error message will be displayed on
the screen and will remain in that condition until the error has been rectified
and the game again powered-up.
(See 6-3 page 45). The following screen will be displayed.
BIKE INITIALIZATION
RELEASE THE ACCELERATOR AND
BRAKE LEVER, PUT THE MOTORCYCLE
AND STEERING BACK TO ORIGINAL
POSITION.
5 SECONDS TO COMPLETE
BIKE INITIALIZATION
INITIALIZATION COMPLETED
GAS
BRAKE
STEER
BANK
RETRY
EXIT
ENTER:
Page 54
0000
0000
0000 CENTER
0000 CENTER
CHOOSE: