Install The Litter Tray; Install The Privacy Hood - Petsafe ScoopFree Ultra Manual De Funcionamiento

LED Indicator Light
The LED Indicator Light is located on top of the Litter Box. It tells you the status of the Litter Box and can help you diagnose potential problems.
Function
Litter Box is on
Detection Sensors are triggered by a cat in the Litter Box Flashes green 4 times per second Rake is in Home position
Cat has left the Litter Box
Rake Delay countdown complete
Obstruction or interruption
STEP 2

Install the Litter Tray

1. Place the Litter Tray cover under the Litter Tray (A). The cover is extra protection against leaks and
will be used later for disposal.
2. Record Today's Date of Litter Tray installation and Tray Change Date on the Waste Compartment
label. See the Recommended Litter Tray Replacement chart in the "Changing the Litter Tray" section
to determine the Tray Charge Date.
Note: Using a Litter Tray longer than the recommended period may result in leakage.
3. Lift the Litter Box Frame at the Waste Compartment Lid until it is standing on its end.
4. Position the Litter Tray below the Litter Box Frame. Ensure the Waste Compartment is below the
Waste Compartment Lid (B).
5. Lower the Litter Box Frame onto the Litter Tray (C). You should hear a click confirming the magnets
on the Waste Compartment Lid have connected to the Magnet Contacts on the Litter Tray Waste
Compartment (D). Ensure the Litter Box Frame is level and sitting on the Litter Tray.
6. Open the bag of Crystal Litter by tearing the corner notch. Pour litter into the tray (E). Spread the
litter evenly, but do not put litter under the Waste Compartment. Discard bag.
7. Ensure the LED Indicator Light is on solid green. If flashing, level out the litter so that it is not
blocking the Detection Sensors.
STEP 3

Install the Privacy Hood

The removable Privacy Hood adds more privacy for your cat along with better litter containment and odour control for you..
1. Place the posts on the bottom of the Privacy Hood into the holes on the top of the Litter Box (A).
2. Insert the posts at the back of the Litter Box first and then the front. The Privacy Hood should fit snuggly
into all four holes.
6
Indicator Light
Solid green
Flashes green once per second
Flashes green once per second
Flashes green 8 times per second Refer to the "Troubleshooting" section for solutions
www.petsafe.net
Rake/Action
Rake is in Home position
Rake Delay countdown is activated
Automatic raking is in process
A
C
A
B
D
"Click"
E
Back
Front
. .