Install The Pet Door Through A Wall With The Smartdoor; Conversion Kit; Key Definitions - Petsafe SmartDoor PPA19-15791 Manual De Adiestramiento

.
Install the Pet Door Through a Wall
with the SmartDoor
SmartDoor
™
extension conversion kit frames out exposed areas, giving your door installation a clean,
smooth, finished look. For brick, concrete or block wall construction an additional
extension is available for the Large Conversion Kit. Note: The SmartDoor
Kit is designed to be recessed into the brick and does not require additional tunnel
extensions. You may purchase a SmartDoor
selected online websites, www.petsafe.net or by calling our Customer Care Centre. See
"Replacement Parts" section for more information.

Key Definitions

Radio-Frequency Technology – The use of a radio-frequency signal that can be
transmitted without wires.
SmartKey
transmitter that sends a unique code to the SmartDoor
SmartDoor
intelligent receiver using an internal antenna to pick up a unique SmartKey
selective pet entry and exit.
SmartDoor
sun protection.
Antenna - The antenna is located inside the Pet Door and receives radio signals from
the SmartKey
certain proximity of the antenna in order for the unique code to be read.
Radio-frequency Interference – Radio-frequency interference is due to radio-
frequency signals from other household appliances or common electronic products
that negatively affect the ability of the Pet Door to receive a signal from a SmartKey
Electronic Key. Radio-frequency interference or "noise" can come from a variety of
sources. Interference can be minimal, constant or ever changing based on usage and
closeness of other electronic household items during the Pet Door's operation. It is
recommended that household appliances and common electronic products be placed
at least 60 cm away from the location of the Pet Door.
Sensitivity Knob – Conveniently placed on the interior frame of the Pet Door is the
sensitivity knob. You can easily adjust the sensitivity of the Pet Door, taking into account
common interferences and environmental factors to optimise Pet Door operation.
Sensitivity Level – The level of sensitivity can be adjusted by turning the sensitivity
knob from minimum to maximum, depending on radio-frequency interference and the
application and/or location of the Pet Door. Pre-set from the factory, the sensitivity level
should not be adjusted until after installation. For example, the sensitivity level may need
6
Conversion Kits are available for wall installation applications. The wall
Electronic Key – A SmartKey
™
Electronic Pet Door – The SmartDoor
™
Flap – The SmartDoor
™
Electronic Key. The SmartKey
™
™
Conversion Kit or large extensions through
™
Electronic Key is a battery-operated
™
flap is a weather resistant, plastic flap with UV
™
Electronic Key must be located within a
™
www.petsafe.net

Conversion Kit

.
™
Electronic Pet Door is an
™
Conversion
™
code for
™
™