Install And Lock Anchor Into The Ground; Attach Anchor To Kennel - Petsafe 900672 Instrucciones De Instalación

Step

Install and Lock Anchor into the Ground

1
1. Gather one anchor, one wire clamp, the
driving rod, hammer and adjustable wrench.
2. Begin on the outside corner of the kennel.
Insert the driving rod into the anchor.
Starting no more than 4" away from the
bottom corner rail of the kennel, begin
driving the anchor into the ground at an
angle toward the inside of the kennel.
3. Drive the anchor into the ground to a
minimum depth of 12" but no more than
18". Be sure to leave enough of the wire
cable above ground to secure around the
kennel frame.
4. Once anchor is in the ground, remove the
driving rod. Wrap the exposed wire around
the driving rod and secure with the wire
clamp. Grab the driving rod and pull
upward 4 to 5 inches to lock the anchor into
the ground. Remove wire clamp.
__________________________________________________________________
Step

Attach Anchor to Kennel

2
1. Gather one wire clamp and adjustable
wrench.
2. Wrap the wire cable around the corner
vertical frame rails of the kennel so that
the wire clamp will be to the outside of the
kennel. Attach the wire clamp around the
wire cable and tighten with the adjustable
wrench.
3. For the safety of you and your dog, it is
recommended that you trim any excess wire
cable to a minimum of 1" using heavy-duty
wire cutters.
Repeat Steps 1 and 2 to anchor the remaining
corners of the kennel.
4 1-888-632-4453