Troubleshooting; Technical Data - Urrea EB1006 Manual De Usuario Y Garantía

Esmeriles de banco
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

NOTE: Using a metal object, like a screwdriver,
is not recommended as it may damage the
grinding wheel.
5. Remove the hex nut (8), the wheel flange (9)
and the wheel (10).
NOTE: The nut on the right side of the grinder
has a standard right-hand thread (turn coun-
terclockwise to loosen). The one on the left
side has a left-hand thread (turn clockwise to
loosen). Both wheel nuts tighten when turn-
ing toward the rear of the grinder and loosen
when turning toward the front of the grinder.
6. Inspect the wheel (10) for cracks, chips or
any other visible damage (other than normal
wear) and discard if such damage is found. In-
spect the blotter/ cardboard disc for damage. If
the blotter is missing or severely damaged, re-
place it with a piece of thin cardboard or blot-
ter paper cut in the same shape. NEVER USE A
GRINDING WHEEL WITHOUT A BLOTTER.
7. Install the new wheel or other accessory.
Make sure both wheel flanges (9) are in place
with the concave sides toward wheels.
8. Place a wood wedge (7) (not supplied) be-
tween the wheel and the wheel cover.
NOTE: Do not overtighten the nut as this can
crack the grinding wheel (10).
9. Replace the wheel cover and screws.
10. Adjust the tool rest to 1/8 in. (3.2 mm) away
from the wheel and tighten securely.
11. Reattach and adjust the eye shield to a
point between your eyes and the wheel.
12. Set the spark guard 1/16 in. (1.6 mm) away
from the wheel.

TROUBLESHOOTING

MOTOR WILL NOT RUN
1. Not plugged into power outlet. Plug it into
the power outlet.
2. Switch and key not in ON position. Insert
key and turn the switch ON.
17
3. Motor cord cut or abraded. Contact nearest
Service Center or Authorized Service Station
for repair or replacement.
4. Plug on cord is faulty. Contact nearest Ser-
vice Center or Authorized Service Station for
repair or replacement.
5. Faulty motor. Contact nearest Service Cen-
ter or Authorized Service Station for repair or
replacement.
6. Fuse on circuit breaks open. Re-set; may be
too many machines on line.
GRINDING WHEEL VIBRATES OR SHAKES
1. Grinding wheel is not fixed properly. Adjust
grinding wheel properly. See ADJUSTMENT
section.
2. Other. Contact nearest Service Center or Au-
thorized Service Station for repair or replace-
ment.

TECHNICAL DATA

EB1006
VOLTAGE-FREQUENCY
SPEED
WHEEL CAPACITY
WHEEL CENTER
POWER
WEIGHT
EB1008
VOLTAGE-FREQUENCY
SPEED
WHEEL CAPACITY
WHEEL CENTER
POWER
WEIGHT
120 V ~ 60 Hz
(2 000 - 3 400) r/min
6" (150 mm)
1/2" (12,7 mm)
250 W (1/3 HP)
12,4 kg (27,3 lb)
120 V ~ 60 Hz
(2 000 - 3 400) r/min
8" (203 mm)
5/8" (15,8 mm)
570 W (3/4 HP)
19,2 kg (42,3 lb)
Tabla de contenido
loading

Este manual también es adecuado para:

Eb1008

Tabla de contenido