Assembly Instructions - Urrea EB1006 Manual De Usuario Y Garantía

3. WORK LIGHT.
4. SAFETY SHIELD AND SPARK DEFLECTOR. The
safety shields and spark deflectors are adjust-
able for operator convenience.
Operating the grinder without these features
attached could result in serious injury. Do not
grind with the safety shield raised; always wear
safety glasses for personal protection.
5. WORK REST. The work rests are indepen-
dently adjustable to compensate for wheel
wear. Before grinding, make certain the work
rests are adjusted properly. Generally the ob-
ject being ground is done slightly above center
of the grinding wheel. Adjust the distance be-
tween the wheel and the work rest to maintain
1/16" (1,6 mm) or less separation as the diam-
eter of the wheel decreases with use.
6. CONTROL SPEED KNOB.
MOTOR: This machine induction motor, has
the power and capacity to work with even the
toughest materials.

ASSEMBLY INSTRUCTIONS

WARNING: Always disconnect the bench
grinder from the power source before per-
forming any assembly or adjustment. Failure to
do so could result in accidental starting result-
ing in possible serious personal injury.
INSTALLING THE SPARK GUARDS
1. Attach the right spark guard (1) to the ex-
tended pad (2) of guard by using the bolts (3),
spring washers (4) and flat washers (5).
2. Repeat for the left side spark guard.
NOTE: As the wheel wears down, the spark
guards must be re-adjusted to maintain a 1/16
in. (1.6 mm) distance.
INSTALLING THE EYE SHIELDS
1. Attach the right eye shield (1) to the spark
guard (2) by using the locking nut knob (3),
lock washer (4) and the carriage bolt (5).
14
2. Repeat for left
side eye shield.
NOTE: Adjust eye
shields to appro-
priate distance
from tool rests
avoiding interfer-
ence when opera-
tion.
WARNINGS:
• Always spin the wheel by hand before turn-
ing on the grinder to make sure the spark de-
flector doesn't hit the grinding wheel.
• Always make sure your bench grinder is
securely mounted to a workbench or an ap-
proved work stand. Failure to do so could re-
sult in an accident resulting impossible serious
personal injury.
INSTALLING TOOL RESTS
1. Insert the lock knob (1) through the flat
washer (2) and the right side tool rest (3) to
the right side tool rest mounting bracket (4) as
shown.
NOTE: The
grooved tool rest
mounts on the
left side
2. Remove the knob (5), lock washer (6) and
flat washer (7) from the carriage bolt (8) on the
lower portion of the wheel guard.
3. Attach the tool rest assembly (9) to the
grinder as shown.
4. Replace the washers and the lock knob (5).
5. Repeat the procedure for the left side tool
rest.
NOTE: When in use, the tool rests should be ad-
justed to within 1/8 in. (3.2 mm) of the grind-
ing wheel or other accessory being used.