Maintenance; Environmental Protection/Disposal; Warranty; Declaration Of Conformity - Protool CSP 85 / 45 EB Manual De Instrucciones Original

10 Maintenance

- The unit should be stored in a dry place
where it is protected against freezing.
WARNING
To verify that the protective insula-
tion remains intact, the machine must
be subjected to a technical safety test
afterwards. For this reason, this work
must be performed exclusively by a
professional electro-workshop.
- With each changing of the saw blade, re-
move deposited saw dust from the inside
of the protective guard.
- The ventilation slots on the motor casing
should be cleaned out from time to time.
After an operating period of approx. 200
hours, the following maintenance work
must be performed:
- Check the motor brushes and replace if
necessary. Clean the motor housing.
- Renew the grease fi lling of the gear-
box.
11 Environmental
Protection/Disposal
Power tools, accessories and packaging
should be sorted for environmental-friendly
recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical and elec-
tronic equipment and its incorporation into
national law, power tools that are no longer
suitable for use must be separately collect-
ed and sent for recovery in an environmen-
tal-friendly manner.

12 Warranty

For our tools, we give warranty for material
and production defects in accordance with
the locally applicable legal provisions, but
in any case for at least 12 months. Within
the EU member states, the warranty period
is 24 months (verifi cation through invoice
or delivery note).
20
Damage caused by, in particular, natural
wear, overloading, incorrect handling, or
damage caused by the operator, or dam-
age caused through use of the equipment
contrary that specifi ed in the Operating In-
structions, or damage which was known at
the time of purchase, is not covered by the
warranty. Furthermore, damage caused by
the use of non-original PROTOOL accesso-
ries and consumable material (e.g. sanding
pads) is also excluded.
Complaints can only be recognised if the
tool is returned while still assembled to the
supplier or an authorised PROTOOL Cus-
tomer Service workshop. Keep the Operat-
ing Instructions, Safety Instructions, Spare
Parts List and purchase receipt in a safe
place. Otherwise the respective, current
warranty condi tions of the manufacturer
shall apply.
Note
Due to continuous research and develop-
ment work, we reserve the right to make
changes to the technical content of this
documentation.
13 Declaration of
Conformity
We declare under our sole responsibility
that this product is in conformity with the
following standards or standardization doc-
uments:
EN 55 014-1, EN 55 014-2, EN 60 745-1,
EN 60 745-2-5, EN 61 000-3-2, EN 61 000-3-3
according to the provisions of the regula-
tions 98/37/EC, 2004/108/EC.
08
Manfred Kirchner
Research and development
Protool GmbH
Wertstr. 20
D-73240 Wendlingen
31.7.2008