Maintenance; Environmental Protection/Disposal; Warranty; Declaration Of Conformity - Protool CSP 132 E Manual De Instrucciones

10 Maintenance

- The unit should be stored in a dry place
where it is protected against freezing.
WARNING
To verify that the protective insulation
remains intact, the machine must be
subjected to a technical safety test af-
terwards.
For this reason, this work must be per-
formed exclusively by a professional
electro-workshop.
- With each changing of the saw blade, re-
move deposited saw dust from the inside of
the protective guard.
- The ventilation slots on the motor casing
should be cleaned out from time to time.
After an operating period of approx. 200 hours,
the following maintenance work must be per-
formed:
- Check the motor brushes and replace if
necessary. Clean the motor housing.
- Renew the grease filling of the gear box.
11 Environmental Protection/
Disposal
Power tools, accessories and packaging should
be sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive 2002/96/
EC on waste electrical and elec tronic equip-
ment and its incorporation into national law,
power tools that are no longer suitable for use
must be separately collect ed and sent for re-
covery in an environmen tal-friendly manner.

12 Warranty

For our tools, we give warranty for mate-
rial and production defects in accordance with
the locally applicable legal provisions, but in
any case for at least 12 months. Within the
EU member states, the warranty period is 24
months (verification through invoice or deliv-
ery note).
Damage caused by, in particular, natural wear,
overloading, incorrect handling, or damage
24
caused by the operator, or dam age caused
through use of the equipment contrary that
specified in the Operating In structions, or dam-
age which was known at the time of purchase,
is not covered by the warranty. Furthermore,
damage caused by the use of non-original
PROTOOL accesso ries and consumable mate-
rial (e.g. sanding pads) is also excluded.
Complaints can only be recognised if the tool
is returned while still assembled to the supplier
or an authorised PROTOOL Cus tomer Service
workshop. Keep the Operat ing Instructions,
Safety Instructions, Spare Parts List and pur-
chase receipt in a safe place. Otherwise the
respective, current warranty condi tions of the
manufacturer shall apply.
Note
Due to continuous research and develop ment
work, we reserve the right to make changes to
the technical content of this documentation.

13 Declaration of Conformity

We declare under our sole responsibility that
this product is in conformity with the following
standards or standardization doc uments:
EN 55 014-1, EN 55 014-2,
EN 60 745-2-5, EN 61 000-3-2, EN 61 000-3-3
according to the provisions of the regula tions
98/37/EC, 2004/108/EC.
08
Manfred Kirchner
Research and development
Protool GmbH
Wertstr. 20
D-73240 Wendlingen
18.07.2008
EN 60 745-1,