Alpine CVA-1003 Manual De Operación página 49

To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries
various noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Foot Brake Lead/Parking Brake Lead Connection
If necessary, use a pinch connector to connect the foot brake lead, parking brake lead, etc.
1
Vehicle Cable
FOOT BRAKE
(Yellow/Black)
CVA-1003
PARKING BRAKE
(Yellow/Blue)
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
CVA-1003
NOTE
If your vehicle has no ACC power supply, add an SPST
(Single-Pole, Single-Throw) switch (sold separately). If
the switched power (ignition) lead of the CVA-1003 is
connected directly to the positive (+) post of the vehicle's
battery, the CVA-1003 draws some current (several
hundred milliamperes) even when its switch is placed in
the OFF position and the battery may be discharged.
All manuals and user guides at all-guides.com
Installation and Connections
Pinch Connector
Monitor Cable
Stopper
Foot brake lead
Pinch Connector
Pinch Connector
Parking brake lead
IGNITION
(Red)
BATTERY
(Yellow)
2
Foot brake lamp
Foot brake switch
Parking brake lamp
Parking brake switch
SPST SW (Optional)
Pliers
Chassis
Battery
Battery
47
-EN