Assembly And Connection Evaluation; Initial Configuration; Blueface And Think Thermostats; Important - Airzone ZS6 Manual Del Usuario

ASSEMBLY AND CONNECTION EVALUATION

Check the following aspects:
- The state of the LEDs of the main control board and the rest of control elements. Check the self-diagnose section of
the data sheet of the elements.
ES
- Main control board LEDs of opening dampers light up sequentially.
EN
- Wired and wireless thermostats power supply.
Important: In the Main Control Board, check the correct performance of D3, D11 and D19 LEDs and motorized elements.
FR
IT
PT
DE

INITIAL CONFIGURATION

BLUEFACE AND THINK THERMOSTATS

Important: Once the setup has been started, it must conclude. You will be able to modify the desired parameters later.
Language
Select your language. These are the available languages: Spanish, English, French, Italian, German and Portuguese.
To associate a wireless Think thermostat, start the radio channel search:
Setting wireless device
- Open the radio channel. To do that, press on SW1. The LED D19 will remain solid red. Once
open, you have 15 minutes to make the association. If that period of time expires, start the
process over again. Remember not to open more than one module at the same time, it may
alter the process. You can also open the channel association radio through the Blueface and
Think (see section System parameters).
IMPORTANT: not to open more than one radio channel at the same time, it may alter the
process.
- Start the radio channel search, to do so, press Airzone to start the search.
Verify the range is correct (30% minimum) and confirm.
-
28
Meaning
Main control board
D3
activity
Main control board
D11
power
Association channel
D19
active
Open dampers
Close dampers
Blinking Green
Solid Red
Solid Red
Solid Green
Solid Red