Zone Reset; System Reset; Changing Batteries - Airzone ZS6 Manual Del Usuario

polarity. Connect the terminal to the power supply input and tighten the cable gland to attach the power supply cable.
According to the current local and national regulations, it is mandatory to add a switch (or other element
to disconnect the system) to the external supply wiring so that a constant separation between poles is
guaranteed. The system will restart automatically if the supply is eventually turned off. Use an
independent circuit from the controlled system for the power supply.
Remember: Once all the connections are made, make sure you replace the cover properly.

Zone reset

If needed, to reset a zone follow the steps shown in the section Advanced Settings, Zone Parameters for Blueface and Think
thermostats and the section Lite thermostat Reset if using Lite thermostats.

System reset

If you want to return to factory values, press and hold SW1 until LED D19 stops blinking. Wait for the LEDS
to go back to their normal state before starting with the initial configuration process.

Changing batteries

To replace the battery, separate the thermostat from its support and
replace the battery (CR2450).
Important:
We recommend using of top-brand batteries. Using low-quality
batteries may reduce the duration of use
Remember to deposit the old battery into an appropriate recycling point.
Note: Do not forget to remove the security system before taking away the
thermostat from the wall.
.
ES
EN
FR
IT
PT
DE
27