Advanced Settings - Think Thermostat; Incidences - Airzone ZS6 Manual Del Usuario

ADVANCED SETTINGS – THINK THERMOSTAT
To access the advanced configuration menu of the Think thermostat, follow the following steps:
ES
EN
FR
IT
PT
· Associated outputs. It displays and allows you to select the control outputs associated with the thermostat.
· Thermostat settings. Use this parameter to define the thermostat as Master or Zone.
DE
*Note: It cannot be configured as Master if there is already another Master thermostat.
· Mode menu. The thermostats can be set in Basic or Advanced mode. They are set in advanced mode by default. These
are the parameters you can control in basic mode:
- On/Off.
- Set-point temperature.
- Local ventilation.
- User settings.
If you need to reset the thermostat to advanced mode, access the advanced configuration menu and then activate the
advanced use mode.
· Offset. Allows you to correct ambient temperature that is measured in the various areas or in all of them, due to
deviations by sources of heat/cold nearby, with a correction factor between - 2,5˚C and 2,5˚C in steps of 0,5˚C. It is in
0˚C by default.
·
Weight. This option is used to set the weight of each zone for purposes of determining system operation. The weight
of the zone will be used for calculating the mode (auto-change over) or for calculating heat demands when using
auxiliary heat. Options: Auto or Manual.
Auto (by default). The weight of each zone is automatically assigned based on the number of zones.
o
Manual. Enables to manually define the weight of the zone. Values: 0 to 100.
o
· Reset thermostat. Resets the thermostat returning to Setup menu (see section Initial configuration).

INCIDENCES

If an error message is shown, you can check both the Installation Manual and the Self-diagnosis section. Please visit Myzone
web: myzone.airzone.es/products/
36
Press once Press and hold Press and hold