Removing The Fastener Guide; Inserting The Fastener Guide - Hilti GX 2 Manual Del Usuario

All manuals and user guides at all-guides.com
Note
The magazine cannot be fitted if the nail pusher has not been pulled back until it engages in the
rearmost position.
2. Engage the front end of the magazine with the fastening tool.
3. Pivot the magazine towards the fastening tool as far as it will go.
4. Close the magazine locking catch.
WARNING
Risk of finger injury! Fingers could be pinched when the nail pusher is released.
▶ When disengaging the nail pusher, do not release it and allow it to jump forward. Guide it forward
slowly as far as it will go.
5. Release the nail pusher and guide it forward as far as it will go.

8.5 Removing the fastener guide

1. Remove the battery. → page 21
2. Remove the gas can. → page 21
3. Unload the magazine. → page 21
4. Move the fastener guide release slider to the EJECT position.
5. Remove the fastener guide.

8.6 Inserting the fastener guide

1. Remove the gas can. → page 21
2. Remove the battery. → page 21
3. Unload the magazine. → page 21
4. Push the fastener guide release slider in the direction of the arrow into the EJECT position and hold it
there.
Note
The fastener guide can be inserted only when the slider is held in the EJECT position.
5. Slide the fastener guide into the slot in the nose of the fastening tool until it is heard to engage.
6. Check that the fastener guide is seated correctly.
8.7 Removing the support leg
1. Release the support leg engaging mechanism by pressing lightly.
2. Pivot the support leg until it can be withdrawn from the locating groove.
8.8 Fitting the support leg
1. Insert the support leg in the locating groove.
2. Pivot the support leg downwards until it engages.
9 Remedying possible malfunctions
9.1 Removing foreign objects from the area of the fastener guide
1. Remove the battery. → page 21
2. Remove the gas can. → page 21
3. Unload the magazine. → page 21
4. Remove the magazine. → page 21
5. Remove the fastener guide. → page 22
6. Remove all foreign objects from the area of the fastener guide.
7. Insert the fastener guide. → page 22
8. Fit the magazine. → page 21
22 English
Printed: 03.03.2017 | Doc-Nr: PUB / 5336064 / 000 / 00