Tabla de contenido
Idiomas disponibles
Idiomas disponibles
COMPONENTS
1
Spindle for outer thread M16x1.5
2
Spindle for outer thread M18x1.5
3
Spindle for outer thread M20x1.5
4
Spindle for outer thread M22x1.5
5
Spindle for outer thread M24x1.5
6
Spindle for outer thread M27x1.5
7
Spindle for outer thread M30x1.5
8
Spindle for inner thread M14x1.5
9
Spindle for inner thread M16x1.5
10 Collar nut
11 Support sleeve, Ø 39 x 29 mm
12 Support sleeve, Ø 46 x 36 mm
ATTENTION
Read the operating instructions and the included safety information carefully before using the product.
Use the product correctly, with caution and only for the intended purpose. Failure to observe the
safety instructions can lead to damage, injury and voiding of the warranty. Keep these instructions in
a safe and dry place for future reference. Include the operating instructions if you pass the product on
to third parties.
INTENDED USE
This set is used to assemble (pull in) drive shafts and can be used on many vehicles thanks to the wide
range of adaptation options, such as on models from VAG, Mercedes, BMW, Porsche, Peugeot, Renault
and Opel.
SAFETY INFORMATIONS
Do not use this tool set for other purpose for which it is designed.
•
Observe the general safety instructions for garages.
•
•
Keep your work area tidy and clean. Areas or corridors which are untidy increase the risk of injury.
Always use approved eye protection, especially when working under vehicles.
•
•
Ensure a secure and well-gripped stance during fitting.
Check the condition of the tool regularly and do not use it if it is damaged.
•
•
Make sure the tool is properly mounted.
Do not over tighten the spindle or apply excessive force, as this may damage both the tool and the
•
component.
•
The tool is not suitable for impact wrenches. The use of an impact wrench can rupture tool parts
and flying tool fragments can cause injury.
•
This manual serves as a brief guide and does not replace a workshop manual. Always refer to the
vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
Fetten Sie immer die Schraubengewinde, ehe Sie das Werkzeug verwenden.
•
Keep children and other unauthorized persons away from the work area.
•
Do not let children play with the tool or its packaging and keep this tool out of the reach of children.
•
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Drive Shaft Feeder Set
Tel.: 02196 720480
Fax.: 02196 7204820
BGS 8262
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
