Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TOOLS
1 Camshaft encoders fixing tool
2 Camshaft encoders fixing tool
3 Camshaft encoders fixing tool
4 Timing chain pre-tensioning tool
5 Camshaft tool bar
6 Camshaft tool bar
7 Camshaft fixing gauge
8 Camshaft tool post
9 Flywheel locking pin
10 Fastening screws
11 Fastening screws
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INTENDED USE
This tool set is used for setting and checking the engine timing on BMW engines N51 / N52 / N53 /
N54 / N55. The included tools are suitable e.g. for vehicles in the table below, with mentioned
engines.
More information regarding this item and a list of suitable engines and models can be found on our
website:
www.bgstechnic.com
SAFETY INFORMATIONS
•
Keep children and other persons away from the working area.
•
Do not allow children to play with this tool or its packaging.
•
Do not use the tool if parts are missing or damaged.
•
Use the tool for the intended purpose only.
•
Never place the tool on the vehicle battery. There is a risk of a short circuit.
•
Be careful when working on running engines. Loose clothing, tools and other objects can be
caught by rotating parts and cause serious injury.
•
Be careful when working on hot engines because of the risk of burn injuries!
•
If you remove the ignition key before repairing, you can prevent the engine from being started
accidentally and resulting in engine damage.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Engine Timing Tool Set
for BMW N51 / N52 / N53 / N54 / N55
Tel.: 02196 720480
Fax.: 02196 7204820
BGS 70111
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
