Setup; Power On/Off; First Time Setup; Setup-Symbols - Milwaukee M12 PL Manual Original

5 SETUP

This section of the manual covers setting up the features and options of the PIPELINE LOCATOR.
5.1 Power on/off
Press the POWER
The buttons will illuminate, showing that the power is on.
Press the POWER
The PIPELINE LOCATOR will shut off automatically after the time selected in the settings menu.
A signal sounds for 20 seconds, then shut off .

5.2 First time setup

All the settings are saved into the PIPELINE LOCATOR memory and will remain there until changed. The initial
settings will set the FREQUENCIES, VOLUME, BACKLIGHT TIMERS, SOUND CONFIGURATION, UNITS OF
MEASURE, POWER TIMER, and LANGUAGE

5.3 Setup-symbols



5.4 Language

It is recommended to set your LANGUAGE fi rst so that the other menus can be easily read and understood.
1.
2.
3.
512 Hz
Frequency
Speaker Volume
Backlight
Sound Configuration
Units
Auto Power Off
Self test
Language
About
4.
5.
ENGLISH
button to power on the PIPELINE LOCATOR.
button for 2 seconds to power off the PIPELINE LOCATOR.
Press the button
go to...
MENU button - enter the menu options. Also, use to step back (return) to the previous screen.
MODE button - toggle through the selected locate modes and their selected frequencies
UP and DOWN navigation button - move vertically through the menu and to lower and raise
the sensitivity while locating.
SELECT button - press to accept the menu options
POWER button - turn on and off the PIPELINE LOCATOR
 SETTINGS
 LANGUAGE

Bulgarian
Arabic
English
German
Dutch
ABOUT
Meter
Bulgarian
5 min
English
English German
 English
3
Arabic
Dutch
8