BGS technic 8335 Manual Del Usuario página 14

RE-PRESSING TIMING RING (if required)
Re-attach Installer Tool to crankshaft flange using
the Allen-headed bolts A. Hand tighten these bolts.
Push Installer Tool by hand to sealing flange.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Screw large hex nut A onto threaded spindle
by hand until it is in contact with tool body D.
Tighten large
hex nut A to
40 Nm using
torque wrench
Check installation position of timing ring on
crankshaft again (refer to page 4).
If dimension -a- is too small again, tighten the
large hex nut E to 45 Nm using a torque
wrench and check installation position of
timing ring on crankshaft again.
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed