BGS technic 8335 Manual Del Usuario página 11

ATTACHING THE SEAL HOUSING AND SENSOR RING TO THE INSTALLER TOOL
Place seal housing with front side onto
Installer Tool — ensure that tool locating pin
B can be inserted into timing ring hole A.
NOTE: Ensure seal housing lies flat on
Installer Tool.
ATTACHING INSTALLER TOOL WITH SEAL HOUSING TO CRANKSHAFT FLANGE
Crankshaft flange must be free of oil and grease.
Check that the engine is still at TDC. Screw large hex nut B
to end of threaded spindle. Press threaded spindle of Installer
Tool in direction of arrow, until large hex nut B lies against
installer housing A. Align flat edge of Installer Tool on sump
side of crankcase sealing surface and fit the tool and new
seal housing assembly over the crankshaft and onto the
cylinder block.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Push seal housing and support ring for sealing lip
B against surface of Installer Tool while tightening
the three knurled screws A, so that locating pin
cannot slide out of timing ring hole.
NOTE: When installing seal housing, ensure that
timing ring remains fixed in Installer Tool.
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed