Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ATTACHING THE SEAL HOUSING AND SENSOR RING TO THE INSTALLER TOOL
Before fitting the new seal housing, check
that the hole in the timing ring is aligned with
the TDC mark on the seal housing. A plastic
clip holds the ring in the correct position, this
must be removed.
NOTE: The timing ring must not be taken out of the seal housing or turned.
Place seal housing with front side onto clean
flat surface. Push sealing lip support ring A
downwards in direction of arrows until it lies
on flat surface.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Locating hole A on timing ring C must align with
TDC mark B on seal housing.
Upper edge of timing ring and front edge of seal
housing must align (arrows).
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
