DeWalt DWS520 Manual De Instrucciones página 18

TYPE OF MATERIAL TO BE CUT
Solid wood (hard, soft)
Chipboards
Laminated wood, blockboards,
veneered and coated boards
Paper and carton
Wall Cutting (Fig. 12)
1. Place the track saw with the outer guard (V) on a clean, fl at fl oor.
FIG. 12
V
D
2. Press the shoe (D) with the front side on the wall against the
adjusted depth stop.
NOTE: The minimum cut between wall and workpiece is 12 mm.
Dust Extraction (Fig. 1)
WARNING: DO NOT direct sawdust toward yourself or others. To
avoid injury from fl ying sawdust, keep the exhaust nozzle either in the
forward position or in the closed position. DO NOT insert foreign
objects into the exhaust opening.
WARNING: ALWAYS connect the track saw to a dust extractor!
WARNING: ALWAYS use a dust extraction device designed in
accordance with the relevant regulations regarding dust emission.
Your tool is fi tted with a dust extraction outlet (I).
MAINTENANCE
SPEED RANGE
WARNING: To reduce the risk of injury, turn unit off and
3–5
disconnect it from power source before installing and removing
4–5
accessories, before adjusting or when making repairs. An
2–5
accidental start-up can cause injury.
Cleaning
1–3
WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning
the non-metallic parts of the tool. These chemicals may weaken the
12 mm
plastic materials used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
Lubrication
This tool has been lubricated with a suffi cient amount of high grade
lubricant for the life of the unit under normal operating conditions. No
further lubrication is necessary.
Motor Brushes
WARNING: To reduce the risk of injury, DO NOT TIE, TAPE, OR
OTHERWISE LOCK THE ON/OFF SWITCH ON while "running in".
HOLD BY HAND ONLY.
DEWALT uses an advanced brush system that automatically stops the
saw when the brushes wear out. This prevents serious damage to the
motor. Brush systems can be replaced at authorized DEWALT service
centers.
Accessories
WARNING: Since accessories, other than those offered by D
have not been tested with this product, use of such accessories with
16
WALT,
E