System Settings; Video Output; Language Selection; Factory Defaults - TrekStor MovieStation pocket c.uc Manual De Instrucciones

System settings

Tv mode
Under the menu item "TV
the MovieStation automatically selects the appropriate color transmission system.

video output

Under the menu item "TV
between a composite and component video signal (YPbPr).

Language selection

Under the menu item "l

Factory defaults

Under the menu item "F
your hard disk are not deleted when you do this.

12) FAQ

I have connected the MovieStation to my television or my HiFi system. Why is no picture showing on my
television or no sound coming from my HiFi system?
This problem may have several causes. Please check the following items:
i
1) Please ensure that you have selected the correct AV source on your television set.
2) Please check that you have connected the correct cable for the output of the video and audio signals. Information
on the correct connection of the MovieStation to your home entertainment system can be found in the "C
T s M s
THe ReK TOR OVie TATiON TO THe HOMe eNTeRTAiNMeNT sYsTeM
3) Even if you have correctly connected the MovieStation, it is possible that it may be in the incorrect video mode. To
select different modes, press the "TV OuT" button until the picture is correctly presented on your television. Please
be patient during the search for the correct video mode.
I have adjusted the settings of the MovieStation in "S
defaults.
As described in the "C
ONFiguRATiON OF THe
will thereby be set to the delivery state. The saved files are not deleted when you do this.
While using the MovieStation, it no longer responds to my entries.
This problem may have several causes. Please check the following items:
i
1) Please aim the remote control in the direction of the MovieStation so that direct visual contact between these two
devices exists and ensure that the infrared receiver of the remote control or the MovieStation is not covered.
2) Check the batteries in the remote control and, if necessary, replace them with new ones.
EN
40
, " you can select NTsC or PAl as the color transmission system. With "M
MOde
, " you can set the video output signal of the MovieStation. You can choose
OuT
", you can select the menu language of the MovieStation.
ANguAge
", you can restore the original settings of the MovieStation. The files saved on
ACTORY seTuP
" section in these operating instructions.
T s M s " section, execute the menu item "F
ReK TOR OVie TATiON
" or "S " and would like to restore the factory
yStem ettingS
",
ulTisYNC
ONNeCTiNg
". The MovieStation
ACTORY seTuP