Amana 12842126 Guía De Uso Y Cuidado página 22

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 29
Care and Cleaning
Replacing Light Bulbs
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before replacing light bulb. After
replacing light bulb, reconnect power.
To avoid personal injury or property damage,
observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
Upper Fresh Food Section
The upper fresh food light bulbs are located behind the
front panel. Reach behind the panel to remove the
bulbs.
Lower Fresh Food Section
1. Push up on bottom tabs (A) on
light cover. Rotate cover up and
release tabs (B).
2. Remove light bulb.
3. Replace bulb with appliance bulb
no greater than 40 watts.
4. Insert top tabs (B) of light cover
into liner slots and snap bottom
tabs (A) into liner slots.
21
WARNING
CAUTION
Upper Freezer Section
1. Remove ice bin by
lifting front of bin and
pulling out.
2. Remove light shield by
pressing the upper right side of the shield and
rotating downward.
3. Remove light bulb. Replace with appliance bulb no
greater than 40 watts.
4. Rotate the shield upward press in slightly and snap
into place.
5. Replace ice bin by sliding in until bin locks into
place.
Lower Freezer Section
1. Pinch both sides of light cover to remove.
2. Remove light bulb. Replace with appliance bulb no
greater than 40 watts.
A
3. Pinch both sides of the light cover to snap into
place.
Ice and Water Dispenser
B
1. Locate light bulb inside top edge of dispenser
frame. Unscrew to remove.
2. Replace light bulb with an E10 thread 6-watt,
250 volt bulb.
(select models)
Light Bulb
Location
loading

Este manual también es adecuado para:

As2628hekb13