Dispensers Electric Pump Load Only For Dishwashers Equipped With Automatic Dispensers; Checks - Adler AC2-ELECTRONIC Manual De Instrucciones

Page. 12
2.9
During installation it is necessary to load detergent dispensers pumps through
relevant suction and delivery pipes.
Detergent:
Enter the programming menu as follows: open one of the doors, keep
contemporarily G and L push-buttons pressed for a few seconds until wording
"PH" is displayed. Then press push-button A until "dn" appears.
It is possible to manually activate the detergent pump by keeping push-button G
pressed; wait for the suction pipe to be completely full.
Rinse aid
Enter the programming menu as follows: open one of the doors, keep
contemporarily G and L push-buttons pressed for a few seconds until wording
"PH" is displayed. Then press push-button A until "bn" appears.
It is possible to manually activate the rinse aid pump by keeping push-button G
pressed; wait for the suction pipe being completely full.
DISPENSERS ELECTRIC PUMP LOAD ONLY FOR DISHWASHERS
a) Check the level in the wash tank making sure that
when the solenoid valve closes the water is 1-2 cm
below the overflow level.
b) Check that the wash tank temperature is 55 - 60°C by looking at
the thermometer on the control panel.
Check that the boiler temperature is between 75 - 85°C by looking
at the thermometer on the control panel.
c) Check the working order of the automatic surface active agent
dispenser which will, however,
installs the machine
EQUIPPED WITH AUTOMATIC DISPENSERS
be started by the technician who
GB
2.10

CHECKS