Error Messages - Adler AC2-ELECTRONIC Manual De Instrucciones

Page. 16
The machine is able to detect different malfunction conditions.
Here is a short description of what to do if the display shows Er ....
Display
Alarm
message
Er
No Drain
02
"Er.
Thermostop
timeout
03"
"Er.
Tank loading
timeout
04"
"Er.
05
Open tank sensor
Er
06"
"Er.
Open boiler
07
Er sensor
.08"
"er
Too high tank
temperature
ht
"Er
Too high boiler
temperature
Hb"
"Er
Electromechanic
safety
sf"
"Er
Boiler loading
timeout
09"
"Er
Failed rinse cycle
01"
"Er
Level safety
SL"
Attempt to reset
"Er rb"
error 09
Tank thermostop
"Er 22"
timeout
Detected fault description
Check drain tubes and make sure they are not obstructed.
For the machines equipped with "overflow device", make sure it is
not in place.
Should the problem still occur it is likely that the drain electric
pump has failed: contact a service centre.
The boiler temperature did not reach the set point within the
extension of the operating cycle washing phase. The boiler heating
is disabled.
Contact the authorised service centre.
Water level inside the washing tank not reached. Turn the
machine off and on, make sure that the overflow pipes are
fitted correctly and that water supply is open, otherwise
contact the authorised service centre.
Broken tank sensor. The tank heating is disabled. Contact the
authorised service centre.
Broken boiler sensor. The boiler heating is disabled. Contact the
authorised service centre.
B4 > MaxTankTemp. The tank heating is disabled.
B2 > MaxBoilerTemp. The boiler heating is disabled.
It is likely that a safety thermostat has been triggered.
Turn the machine off and on; should the problem still occur,
contact an authorised service centre.
Problem with boiler water loading, make sure the water supply is
correctly open and that flow rate is suitable, according to machine
nameplate specifications. Turn the machine off and on; should
the problem still occur, contact the service centre.
The rinse cycle has not been correctly carried out, check that rinse
spraying nozzles are free from any obstruction.
Should the problem still occur, contact the service centre.
Problem with water drain. Drain electric pump has not drained
correctly.
Check drain tubes; should the problem still occur, contact the
service centre.
The machine displays this message when attempting to solve
Problem with boiler water heating. Contact a service centre.
3.4
boiler loading problem.
GB

ERROR MESSAGES