Safety Thermostat; Detergent And Rinse Aid Dispensers And Settings - Adler ECO35 Instalación Uso Y Mantenimiento

breakdown is reseted. It is always possible to
turn Off and On the appliance trought the
button.

SAFETY THERMOSTAT

All machines are provided with a safety
heatswitch that shuts machine off in case of
overheating (120°C/248°F).
thermonstat device press the push-button
behind the control panel of the thermostat.
2D – DETERGENT AND RINSE AID
DISPENSERS AND SETTINGS
Before starting a new cycle the dispenser and its
pipe must be completely filled. Check the level of
the detergent or rinse aid and eventually fill-up
the tank.
N.B.
The level in the detergent or rinse aid tank
must not get empty or filled with corrosive or
inadequate products. The warranty does not
cover damages caused by improper use of
dispenser. The dispenser is calibrated at
manufacturer site: dispenser settings after
installation can be performed only by
qualified specialists.
1- Extract the front panel with Allen tool or
similar by inserting it inside the holes on the
inferior part of the panel. Pull up the panel
carefully. For Hoodtype models, -
unscrew the two screws located on the
bottom of the panel. (Fig.8)
Fig.8
Before removing the front panel make sure the
machine is disconnected from the main
breaker.
2- Insert included dispenser tube inside the
detergent or rinse aid tank. (if available).
(Fig.9)
Fig.9
Setting of rinse aid dispenser is perfomed
acting on the screw accessible after removal
of front panel, under the tank door. (see
Fig.8)
1-
To reset the
dispenser by screwing anticlockwise the
needle valve of the dispenser.
2-
quantity by screwing clockwise the needle
valve of the dispenser. (Fig.10)
Fig.10
Quantity for the first setting should be
according
evaluating the hardness of the water and
the type of rinse aid used. Recommended
vacum standard quantity of rinse aid from
the included tube 4 x 6 correspond to
approximately 4 cm = 0,5cc = 0,5 gr. for
each 50 x 50 standard rack machine.
Otherwise, approximately 2,5 cm = 0,3 =
0,3 gr. for 35 x 35 and 40 x40 standard
rack
permit is approximately 25,8 cm = 3,6 cc =
3,6 gr.
After first setting rinse aid dosage must be
optimize by evaluating washing results after
few cycles.
Setting of rinse aid dispenser is perfomed
acting on the screw accessible after removal
of front panel, under the tank door. (see
Fig.8)
1- Close gently all the way down the
2- Open up
Fig.11
2D1 – PRESSURE RINSE AID DISPENSER
Close gently all the way down the
Open up until reached necessary
to the installator
glasswasher. Maximum
2D2 – PERISTALTIC RINSE AID AND
DETERGENT DISPENSER
dispenser by screwing anticlockwise the
needle valve of the dispenser.
until reached necessary
quantity by screwing clockwise the
needle valve of the dispenser. (Fig.11)
after
dosing
10