Operative Temperature Adjustment - Adler AC2-ELECTRONIC Manual De Instrucciones

GB
The non-observance of such inspections will result in the invalidation of the warranty
It is possible to adjust the boiler water heating temperature (rinse water) and the washing tank
temperature.
Set boiler rinse water:
Switch on the machine, hold line push-button on/off "A" pressed for a few seconds until wording "b
" "78 °C" is displayed. Press G and L push-buttons to increase or decrease the setting.
d) Check the working order of the rinse economiser. It must start to
distribute hot water rinse at system pressure when a rack arrives under
the jets and stop when the rack comes out.
It is recommended that the water in the boiler be cold for this
step.
e) Check the operation of the machine limit switch, which must stop
the drive motor when a basket reaches the end of run. The basket
shall be taken off to restart the operation
f) Check the rotation direction of the pumps and motors, if they rotate
in the opposite direction invert the two phases of the power supply
cable.
NOTE:
Check the rotation of the sledge. The reduction gearbox must
rotate clockwise (as in the figure), otherwise, invert the phase in
the power cable.
WARNING: If the sledge is rotating in the direction opposite to
that shown, the safety feature is disabled!
2.11

OPERATIVE TEMPERATURE ADJUSTMENT

Page. 13
.