1/ Installation; Before Connection; Electrical Connection - Fagor MW-ARG47GEX Manual De Instrucciones

MW4-248 4/4/07 12:12
EN

1/ INSTALLATION

••BEFORE CONNECTION
• Check whether your oven has
suffered any damage during transport
(deformed door or door seal, etc.). If
you see any signs of damage, contact
your dealer before use.
• Verify the power voltage. If there is a
PERMANENT under voltage (200-210
volts), consult your electrical installer.
••ELECTRICAL CONNECTION
• Your installation must be protected by
a 16 Amp thermal fuse.
• It is mandatory to use a power point
with a ground terminal, connected in
accordance with current safety regulations.
• In your electrical installation, provide
a device that is accessible to the installer,
capable of separating the appliance from
the mains power and whose contact
opening is at least 3 mm at all of the
poles.
• Never operate the oven if the supply cord
and/ or its plug are damaged. In case of
damage, call in a specialised technician
trained by the manufacturer.
Página 50
All manuals and user guides at all-guides.com
50
••LOCATION
• The oven must be set on a work surface
at least 85 cm above floor level.
• Place the oven on a flat and horizontal
surface, away from any source of heat
or steam. To ensure the stability of the
microwave oven, the front left foot is
adjustable (5 positions). Turn it to raise
or lower the appliance.
• Make sure that air may circulate freely
around the oven.
Leave sufficient space around the oven :
- 5 cm between the sides of the oven
and any walls or objects
- 14 cm above the oven
- 10 cm behind the oven.
• Allow nothing to obstruct the ventilation
louvers at the back of the appliance.
• Make sure the electrical plug will be
accessible after installation.
• Do not use your appliance immediately
(wait approx. 1-2 hours) after transfer
from a cold place to a warm place as
condensation may cause a malfunction.