Cleaning And Maintenance - cecotec CONGA POPSTAR 29600 AQUA&COLLECT Manual De Instrucciones

Self-cleaning function
Before the self-cleaning cycle:
1. Place the machine on the tray.
2. Insert the charger into the plug.
3. Fill at least 1/2 of the water tank.
4. Press and hold the speed button for 3 seconds to enter the self-cleaning mode, the
indicator light will flash for 3 seconds.
5.
After the self-cleaning ends, the machine will automatically shut down.
Note:
Clean and empty the sewage tank after each self-cleaning cycle.
Fig. 11

5. CLEANING AND MAINTENANCE

Sewage tank cleaning
When the sewage tank is full, the water level float will start operating, the Green light indicator
will blink and the device will start operating intermittently. When this happens:
1. Turn the device off and clean the sewage tank as soon as possible (if you do not shut
down immediately, the device will automatically shut down after 3 seconds).
2.
Once it is turned off, take the upper cover of the sewage tank up by hand and pour out the
sewage from the sewage tank.
3. Pull on the filter to take it out and turn the filter housing anticlockwise.
4.
Rinse the sewage tank, float bracket and float, filter rack and HEPA filter with clean water.
5. After cleaning, install the sewage tank into the device and continue to use it.
Fig. 12
Floor brush assembly cleaning
1. To remove the rolling brush cover, first put your finger on the edge of the rolling brush
cover, push the rolling brush cover up and rotate to remove the rolling brush cover.
2. To release the rolling brush body, use your fingers to pull up the left rolling brush handle.
3. Wipe the empty space of the rolling brush with a dry rag.
4. Place the cover and rolling brush body in clean water to rinse.
5. After rinsing, assemble the rolling brush and frame in place.
6. To install it, hold the rolling brush end cap with your hands, align it with the groove and
put it into the groove until it clicks into place.
7. Then align the buckle at both ends of the rolling brush cover with the grooves at both
ends of the floor brush, and then press the rolling brush cover. A click will indicate the
installation has been completed.
Fig. 13
CONGA POPSTAR 29600 AQUA&COLLECT
ENGLISH
43