Activation And Acceptance Of Gas Devices - Bartscher M 10110g Manual De Instrucciones

If the device is installed under a fume hood, the following conditions must be met:
a) The volume of air removed must exceed the volume of exhaust produced
(see regulations);
b) Material of the filter in the fume hood must be adapted to exhaust
temperatures that may reach up to 300 ° C;
c) The end of the exhaust pipe must be installed inside the circuit at the
base of the fume hood;
d) The gas flow must only be activated manually.

5.1.8 Activation and acceptance of gas devices

Before activating gas devices, perform all inspections that are necessary to ensure
conformance and installation of the device according to statutory regulations and the
recommendations contained in these instructions.
The following conditions must be met:
→ → → → The temperature in the place of installation must exceed + 4 ° C.
→ → → → The cooking compartment must be empty.
→ → → → All packing elements must be completely removed, together with the
protective film on the internal walls.
→ → → → Ventilation ducts cannot be blocked in any way.
→ → → → Any elements of the device disassembled during installation must be
reassembled.
→ → → → The main electric switch must be turned on, and the water stopcock installed
by the device must be open.
When the device is connected to an electricity source, an audible signal may sound.
This is normal, and will automatically turn off after a few seconds.
- 61 -