Ferroli ENERGY TOP B Instrucciones De Uso, Instalación Y Mantenimiento página 60

If the Remote Timer Control (optional) is connected to the boiler, the above ad-
A
justments are managed according to that given in table 1.
Adjustment can be made from the Remote Timer Control menu and the boiler
control panel.
Adjustment can be made from the Remote Timer Control menu and the boiler
control panel.
Summer mode has priority over a possible Remote Timer Control heating
demand.
(with On disabling DHW from the Remote Timer Control menu, the boiler selects the
optional hot water tank installed) Economy mode. In this condition, the button detail 7 - fig. 1 on the boiler panel
is disabled.
On enabling DHW from the Remote Timer Control menu, the boiler selects the
Comfort mode. In this condition it is possible select one of the two modes with
the button detail 7 -fig. 1.
Both the Remote Timer Control and the boiler card manage Sliding Tempera-
ture adjustment: of the two, the Sliding Temperature of the boiler card has prior-
ity.
The filling pressure with the system cold must be approx. 1.0 bar. If the system pressure
falls to values below minimum, the boiler card will activate fault F37 (fig. 14). Flashing of
the arrows (details 18 and 24 - fig. 1) together with the error code indicates which boiler
shell is in fault status.
Once the system pressure is restored, the boiler will activate the 120-second
A
air venting cycle indicated on the display by FH.
THE BOILER MUST ONLY BE INSTALLED BY QUALIFIED PERSONNEL, IN COMPLI-
ANCE WITH ALL THE INSTRUCTIONS GIVEN IN THIS TECHNICAL MANUAL, THE
PROVISIONS OF CURRENT LAW, THE NATIONAL AND LOCAL REGULATIONS,
AND THE RULES OF PROPER WORKMANSHIP.
ENERGY TOP B is a heat generator arranged to operate alone or in cascade (bank).
When two or more generators are installed in cascade with the original kits ENERGY
TOP B, respecting the prescriptionsFERROLIof this manual, they can be considered as
a single heat generator of total power equal to the sum of the powers of all the units con-
nected in cascade.
All the requirements of the current standards and regulations applicable to this "equiva-
lent" total heating capacity generator must be met. In particular, the place of installation,
safety devices and fume exhaust system must be adequate for the total heating capacity
of the bank of units.
In fact, each ENERGY TOP B is a complete and independent heat generator, equipped
with its own safety devices. In case of overtemperature, no water or no circulation in the
unit , the protection devices cause the unit to shutdown , preventing its operation.
The installation instructions given in the following paragraphs concern single units and
connection in cascade.
Given below are the possible configurations for connection in cascade.
All manuals and user guides at all-guides.com
eco reset
comfort
A
cod. 3540S736 - Rev. 00 - 09/2013
80 / /
125 / /
160 /
250 /
160 80 /
160 125 /
250 80 /
250 125 /
160 160 /
250 160 /
250 250 /
160 160 80
160 160 125
250 160 80
250 160 125
250 250 80
250 250 125
160 160 160
250 160 160
250 250 160
250 250 250
160 160 160
160 160 160
250 160 160
250 160 160
250 250 160
250 250 160
250 250 250
250 250 250
160 160 160
250 160 160
250 250 160
250 250 250
250 250 250
250 250 250
250 250 250
250 250 250
250 250 250
120 180
450
900
/ / / 500
/ / / 500
/ / 200 1000
/ / 200 1000
/ / 200 1500
/ / 200 1500
/ / 200 1500
/ / 200 1500
/ / 200 2000
/ / 200 2000
/ / 200 2000
/ / 200 2500
/ / 200 2500
/ / 200 2500
/ / 300 2500
/ / 300 2500
/ / 300 2500
/ / 300 3000
/ / 300 3000
/ / 300 3000
/ / 300 3000
80 / 300 3500
125 / 300 3500
80 / 300 3500
125 / 300 3500
80 / 300 3500
125 / 300 3500
80 / 300 3500
125 / 300 3500
160 / 300 4000
160 / 300 4000
160 / 300 4000
160 / 300 4000
250 / 300 4000
250 80 300 4500
250 125 300 4500
250 160 300 5000
250 250 300 5000
A