Set-Up / Wall Bracket - Nevadent DAZD 3.7 LI B2 Instrucciones De Uso

Ocultar thumbs Ver también para DAZD 3.7 LI B2:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Set-up / wall bracket

The charger
rooms.
In damp rooms, especially in the vicinity of water (bath), the charger
must be firmly fixed to the wall to protect it from falling into water.
1) Pull the wall bracket
2) Using the screw holes of the wall bracket
for the boreholes on the wall. Check to ensure that there is a
power socket in close vicinity.
3) Before drilling the holes, check to ensure that there are no electri-
cal cables or water pipes behind the markings.
4) Use a 5 mm drill bit to drill the required holes and insert the
wall plugs.
5) Secure the wall bracket
6) After you have attached the wall bracket
through the right or left cut-out in the charger
on the fold-out page). Using the guide rails, slide the charger
onto the wall bracket
7) Ensure that the power cord is not trapped and that it lies properly
in the cut-outs.
DAZD 3.7 Li B2
may only be operated free-standing if used in dry
downward from the charger
using the screws provided.
.
:
, mark the spacing
, guide the power cord
(see magnification
US-EN
 9

Capítulos

Tabla de contenido
loading

Tabla de contenido