Set-Up / Wall Bracket - Nevadent DAZD 3.7 Li B2 Instrucciones De Uso

CAUTION – PROPERTY DAMAGE!
The electric toothbrush may only be recharged with the sup-
►
plied charger. The appliance could otherwise be irreparably
damaged!
Only operate the appliance with the original accessories
►
supplied.

Set-up / wall bracket

NOTE
► The charger may only be operated free-
standing if used in dry rooms.
► In damp rooms, especially in the vicinity of
water (bath), the charger
fixed to the wall to protect it from falling into
water.
1) Pull the wall bracket
charger :
2) Using the screw holes of the wall bracket
mark the spacing for the boreholes on the
wall. Check to ensure that there is a mains
power socket in close vicinity.
3) Before drilling the holes, check to ensure that
there are no electrical cables or water pipes
behind the markings.
4) Use a 5 mm drill bit to drill the required holes
and insert the wall plugs.
5) Affix the wall bracket
provided.
■ 34 │ GB │ MT
must be firmly
downwards from the
,
using the screws
6) After you have attached the wall bracket
guide the power cable through the right or left
cut-out in the charger
the fold-out page). Using the guide rails, slide
the charger onto the wall bracket
7) Ensure that the power cable is not trapped
and that it lies properly in the cut-outs.
,
(see magnification on
.
DAZD 3.7 Li B2